Biotechnology Forums
In cell culture, can treated surface survive autoclaving? - Printable Version

+- Biotechnology Forums (https://www.biotechnologyforums.com)
+-- Forum: Information (https://www.biotechnologyforums.com/forum-16.html)
+--- Forum: Questions and Answers (https://www.biotechnologyforums.com/forum-37.html)
+--- Thread: In cell culture, can treated surface survive autoclaving? (/thread-7180.html)



In cell culture, can treated surface survive autoclaving? - walkingfish - 11-09-2015

If I treat a surface for cell adhesion with fibronectin, collagen, etc., can I autoclave it and expect it to function in allowing the attachment of mammalian cells?  Since denatured collagen is used to promote adhesion, it seems like it might be feasible, but I don't know.  If this is a less than optimal idea, does anyone know of any alternatives?  If anyone has any insight, I'd appreciate it.  I'll thank you in advance.


RE: In cell culture, can treated surface survive autoclaving? - stevewoods - 11-09-2015

(11-09-2015, 02:45 PM)walkingfish Wrote: If I treat a surface for cell adhesion with fibronectin, collagen, etc., can I autoclave it and expect it to function in allowing the attachment of mammalian cells?  Since denatured collagen is used to promote adhesion, it seems like it might be feasible, but I don't know.  If this is a less than optimal idea, does anyone know of any alternatives?  If anyone has any insight, I'd appreciate it.  I'll thank you in advance.

Heating does lead to gelatinization of collagen, but you can't use too concentrated gelatin for adhesion. So, I am not sure if that would be an optimal way out. Ideally you should be using filter sterilized collagen solution for treating your (autoclaved) surface under the hood. That is more of a standard procedure.

Hope it helps


RE: In cell culture, can treated surface survive autoclaving? - walkingfish - 11-10-2015

Thank you very much.